M K - 3 0 0 3 M A N TOSHIBA
Native| Translation
------+-----+-----+-----
Form 2.5"/SUPERSLIMLINE Cylinders | | |
Capacity form/unform 3080/ MB Heads | | |
Seek time / track 13.0/ ms Sector/track | | |
Controller IDE / ATA3 Precompensation
Cache/Buffer 128 KB Landing Zone
Data transfer rate MB/S int Bytes/Sector 512
16.600 MB/S ext PIO4
Recording method operating | non-operating
-------------+--------------
Supply voltage Temperature *C 5 55 |
Power: sleep W Humidity % 8 80 |
standby W Altitude km |
idle W Shock g |
seek W Rotation RPM
read/write W Acoustic dBA 35
spin-up W ECC Bit
MTBF h 300000
Warranty Month 36
Lift/Lock/Park YES Certificates
**********************************************************************
L A Y O U T
**********************************************************************
TOSHIBA MK3003MAN HDD-2619 JUMPER SETTING
+-+
43-------------------------------------------1+C+A+
|* * * * * * * * * * * * * * * * * * * * * * *|*|*|
---+* * * * * * * * * * * * * * * * * * * * * *|*|*+-----
44-----------------------+-------------------2+D+B+
| +-+
Polarity Key
**********************************************************************
J U M P E R S
**********************************************************************
TOSHIBA MK3003MAN HDD-2619 JUMPER SETTING
Jumper Setting
==============
Master/Slave Configuration
--------------------------
Drive address is set by the optional jumper of the interface
connector.
If jumper is open, drive is set to be Master.
If jumper plug is inserted into position C - D, drive is set to be
Slave.
If jumper plug is set with position B - D and P28 (CSEL) signal is
low, drive is Master drive.
If jumper plug is set with position B - D and P28 (CSEL) signal is
high, drive is Slave drive.
In case of using 2 Drives one must set as Master and the other is
set to Slave.
In case of using single Drive, drive must be set as Master.
PROHIBIT!!
A-B JUMPER
A-C JUMPER